DFI UT N4 SLI-DR Help ( 3 Views )

1. Ok, I have this new board (listed in title) and AMD 3800+. For some reason this machine wont POST with my RAM.
   
   I am using Corsair XMS (PC3200) 4x 512 = 2GB of RAM.
   
   The board says that it supports 2GB's and PC3200 DDR RAM so I don't know why if I load all 4 DIMM's with RAM, I get no POST. The machine powers on but the monitor sits in stand-by with an amber light rather than a green light. I have only had success by adding in 1 DIMM of 512MB's in DIMM2 slot. I have used each piece once in DIMM2 to make sure none of the RAM is bad and they all work but when I add more than once piece, no boot screen and or POST. If I add that same piece from DIMM 2 in DIMM1, no boot.
   
   Can someone please help me. I atleast want to be able to use 1 GB of my RAM and it seems this board is not happy and I need to find out why. I have reverted back the BIOS settings to fail-safe so nothing should be out of the ordinary.
   
   Thanks
   
   
   (furkan, Iraq)


2. Do U have all four cables connected? What voltage are U giving your CPU and your Memory? Are U on AUTO settings? Do U have cpc disabled?
   
   Also a spec on your hardware please (incl. PSU)
   
   or simply goto: www.dfi-street.com start by creating a sig w. all Hardware in it and then read rules and stickies after that goto oc forum and readup on memory settings and timing.
   
   
   (elif, Djibouti)


3. What four cables connected? I am noy over clocking or doing anything crazy. All the voltage is what it shoud be I guess since I have not made any changes to anything. I restored BIOS fail safe defaults and just plugged everything in and fired the system on. I have no idea what CPC is.
   
   System Specs
   
   Antec 550 PS
   Antec Case
   AMD 64 3800+
   DFI Lan Party UT N4 SLI-DR
   Nvidia 7800GTX
   Corsair XMS DDR (PC3200) x4
   WD 120GB S-ATA
   TDK 840G Dual Format DVD Burner
   
   
   (aybüke, Saint Helena)


4. Ok I think its DFI-street time 4 U... the four cables (the 24pin the 4pin the Molex and the floppy) should all be conected to the MoBo for stability purpose not for overclocking or crazyness. Then U need to go into the BIOS and up the RAM Voltage to 2.7V and the CPU special to 110% also disabe QnC, cpc and the DFI splashscren.
   
   
   (osman, Myanmar)


5. Ok, Yes - all 4 cables have been connected. I connected the motherboard cable - the 4 pin power cable that is normally used for Pentium 4's, the strange molex connector by the card and the floppy connected by the PCI-E.
   
   Let me check with the BIOS settings as you indicated.
   
   Thanks!
   
   
   (gülçin, Somalia)

Related Topics ... (or search in 1.720.883 topics !)